EZCURB™ Curbing Release Powder
- Keeps mats and rollers from grabbing fresh concrete
- Fine pigments leave an antiqued accent in the texture
- Water-repelling blend for a crisp, clean release
- Roll it, throw it, or brush it on
- Free shipping, always
- 30-day money-back guarantee
- Made in-house by Specco Industries
- No calcium chloride, ever
Built to pull away clean.
Stamped texture only looks pro if the mat lets go. This pail is the difference between crisp and torn.
- Stuck matsThe stamp mat grabs wet concrete and tears the texture off the face.Water-repelling additives keep fresh concrete from adhering to mats and rollers.
- Torn textureEvery pull-away gouges the curb and you re-tool the same foot twice.A clean release means the pattern lands once and stays crisp.
- Flat, one-tone colorA single color reads plain and hides the texture you just stamped.Fine pigments settle into the texture for a two-tone antiqued accent.
- The redo taxSticking and patching eat the minutes that were supposed to be profit.Roll it, throw it, or brush it on, and keep the run moving.
The straight facts.
Off the label. What a pail of release actually does.
Hot pours set faster and grab harder, which makes a clean release matter even more. The Heat Wave pack keeps the mix on your side, and 3 or more Heat Wave pails run 15% off every pail.
Shown over a gray cement mix at the recommended rate. Job-site results vary.
Watch the full run-through.
Roll it, throw it or brush it, start to finish.
Runs with the Heat Wave pack.
A clean release starts with a mix that behaves.
EZCURB™ Curb Retarder